Need help?Do you have a question about the Quest Engineering X10 and is the answer not in the manual?
General| Brand | Quest Engineering |
|---|---|
| Model | X10 |
| Category | Metal Detector |
| Language | English |
Instructions for assembling the metal detector shaft for adult users.
Instructions for assembling the metal detector shaft for junior users.
Explanation of the device's control buttons and their functions.
Description of the target ID bars, digit ID, battery, and audio level indicators.
How to swing the coil and overlap sweeps for effective target detection.
Using the pinpoint button to precisely locate detected targets.
Methods for excavating targets while minimizing soil disturbance.
Guidelines for connecting and using headphones to prevent hearing damage.
Instructions on how to recharge the metal detector via USB.
How the detector categorizes metal signals by conductivity and uses visual bars.
Overview of different detection modes like Coin, Jewelry, and All Metal.
How to calibrate the detector to soil conditions to reduce noise.
How to control the detector's power level and signal gain for optimal detection.
Explanation of different audio tone outputs for target identification.
How to filter out unwanted metal targets based on conductivity.
Crucial warnings regarding device handling, storage, and protection.
Step-by-step guide on how to clean the metal detector safely.
Table of problems like no power, noise, or no sound with their remedies.
Steps to restore the device to its default factory settings.
To Next Page
