Quest Engineering X10

HEADPHONES & RECHARGE
Tak e o ff mo istu re an d
dust cover to access
ports. Put it back to place
to avoid damage by liquid
or dirt.
You can use headphones,
earphones with 3.5mm
diameter type connector.
Set to low audio volume
b e f o r e w e a r y o u r
headphones to avid
hearing damage.
Connect the micro USB
cable to a wall charger
with USB port.The battery
indicator will stop flashing
when fully charged.
Please allow 4 hours to
refresh the X10.
04:00Hr FULL