PROGRAMING
TONES
X10 output high tone and middle tone depends on the target ID so you can use your ear to make quick
decision. Most experienced detectorists use this technics.
C1: one mid tone without iron bass C2: one mid tone with iron bass C3: 3 tones bass mid and high
C4: 4 tones C5: 5 tones C6: pitch tones or variable tones depends on signal strength
TARGET ID SELECTION (Discrimination)
When the function is selected, one of the bars will start flashing, use up or down button to move
the flashing bar forth or back, press MENU button to select or deselect the bar. Press PINPOINT
button to return to detecting condition.
Some of valuable target may mixed with trashy zones such as some coins and alloys.
THRESHOLD
Threshold function is only available for All Metal mode. It controls the background noise level so you can hear
more signals. You can adjust it from -9 to +9. The higher digit will allow you to hear more weak signal from
target. To detect more silently you can set the digit lower.
Press up / down button once for fine adjustment. Press and hold button to change the digit faster.
To Next Page
Loading...
Need help?
General
