Quest Engineering Q30

14
Detecng
For searching, move forward slowly and swing the
coil approximately 3 cm above the ground from le to
right as shown in the graphic on the le. Your detec-
tor will only scan for objects if the search coil is mo-
ving. Your swings should overlap each other to cover
the whole ground. The coil should always stay at the
same distance and parallel to the ground.
Please note: Before searching, check if a permit is needed to search at the respecve
locaon, and/or if you need permission of the owner.
9. Operaon
Underwater search
The Q30 is waterproof, so you can take it under water up to 5 meters. For underwater
search, please note:
- If you are searching without the oponally available waterproof headphones, make
sure that the headphone jack protecon cap on the backside of the control unit is
properly closed and acvate the vibraon by using the volume regulaon.
- Switch to Saltwater mode, since saltwater is highly conducve and the detector
would get to many signals otherwise.
- Aer underwater search, rinse the detector with clean water, then take o the
handle from the rod and allow the inside of the handle to dry completely.