Quest Engineering Q30

17
Please note:
• Do not twist the coil cable and connector to avoid wire damage.
• Do not store the device where prolonged exposure to extreme temperatures can
occur to avoid device damage.
• Never use a hard or sharp object to operate the buons to avoid damage.
• Avoid chemical cleaners, solvents, and insect repellents that can damage plasc
components and nishes.
• Even small amounts of sweat or moisture can cause corrosion of the electrical
contacts when connected to a charger.
• Secure the audio protecon cap ghtly (use a coin if necessary) to prevent damage
to the audio port.
• Clean the surface of the detector everyme aer you use it under water, saltwa-
ter or freshwater. Please take o the handle from rod and allow the inside of the
handle to dry completely each me you return from underwater detecng.
• Pay aenon to the sand when changing coils on the beach. If Sand gets into the
connector, it will void the warranty.
Cleaning the detector:
• Before cleaning, turn o the device and disconnect it from power.
• Wipe the device using a so, clean, lint-free cloth. Dampen the cloth with water or
a mild detergent soluon.
• Wipe it dry. Aer cleaning, allow the device to dry completely.
10. Maintenance