Quest Engineering V80 Quick Start

3
QUICK START
for V80 V60
VER:200111S63EN
QUICK START
ITEMS
V80
V60
V80 Control box
✔
V60 Control box
✔
Carbon fiber rod set
✔
O
Aluminum rod set
O
✔
Armrest+Elbow band
✔
✔
Blizzard11 Coil
✔
✔
Blizzard9 Coil
O
O
WireFree WRXB
✔
O
WireFree Pro HE
✔
O
WireFree Vibe
O
✔
USB Charger+Cable
✔
✔
Headphones Adaptor
✔
✔
Underwater Headphones
O
O
WRXB Receiver
VIBE Headphones
Waterproof
Headphones
PRO HE Headphones
CLICK ONCE TO
PINPOINT, CLICK
AGAIN TO RETURN
Maintenance
•
Do not twist coil tail or connector to prevent wire damage.
•
Store device away from extreme temperatures.
•
Use soft object to operate touchpad to avoid damage.
•
Avoid chemicals, solvents, and insect repellents that can harm waterproofing,
plastics, and finishes. Tightly secure audio protection cap to prevent damage to
audio port.
NOT POWER ON
Coil is not connected. Power is low, please recharge the
detector.
SPEAKER NO ALARM
Check the volume of speaker, or wireless headphones
VERY NOISY
Perform noise canceling. Please find another place with less
interference. Lower sensitivity
NO SOUND
Make sure the Volume is not set to ZERO level and/or wireless
audio has been activated
FALSING WHEN
SEARCHING IN GRASS
Use Velcro tape to secure cable to rod, prevent tangling, and
protect from hard impacts
OVERLOAD ALARM
Please turn to BEACH MODE if you are detecting on the beach
or high mineralized ground.
* Size not to scale
KEEP
50% OVERLAPPING
HOLD AND PUMP
FOR GROUND
BALANCE
QUEST METAL DETECTORS
info@questmetaldetectors.com
6-8 hrs
3
4
5
6
1
2
INSTALLATION
1
Install controler
2
Install armrest
3
Extend rods
4
Connect coil to rod
5
Route coil cable on rods
6
Connect coil to controler
IN THE BOX
RECHARGE
BASIC TECHNICS
2
CLICK TO
SELECT MODE
1
4
HOLD FOR
NOISE CANCELING
CLICK TO
POWER ON
YOU ARE GOOD
TO GO NOW
OK
10 sec
BEACH
GOLD
BLIZZARD9
BLIZZARD11
Carbon-fiber rods
Aluminium rods
Armrest
Controller
Headphones Adaptor
Quick Start Manual
Trouble shooting
Cleaning
•
Clean detector after underwater use, let handle dry completely.
•
Beware of sand when changing coils on the beach.
•
Clean detector with soft, clean, lint-free microfiber cloth.
•
If dampening cloth, turn off device and disconnect from power.
•
Gently wipe screen with microfiber cloth.
✔: included. O: optional

Quest Engineering V80 Specifications

General

Brand	Quest Engineering
Model	V80
Category	Metal Detector
Language	English