11
Commissioning
1. Remove the cup warmer lid (f). Take out the delivery and discharge pipes
and withdraw the water tank.
2. Fill the water tank (g), with drinking water, softened if possible.
3. Return the water tank to its original position.
4. Switch on the machine bringing the switch (h) to position 1; the light (i)
switches on.
5. Raise the group lever (b) to delivery position, wait until approx. ½ litre of
water pours out from the group (boiler full) then lower the lever.
6. Set the switch (h) in position 2 to start the boiler heating; light (j) on.
7. When the heater light (j) switches off, the machine is ready to deliver the
coffee.
Important: Make sure that the silicon tubes are completely immersed in the
water, and are not bent.
Coffee brew
1. Remove the filter (c) holder from its seat, turning it clockwise.
2. Fill the filter with one or two doses of coffee (according to the filter
inserted);
3. Press the coffee with the presser.
4. Place the filter holder to its seat, turning it anti-clockwise.
5. Place the cups under the corresponding outlets under the filter holder.
6. Lift the coffee delivery lever (b) after a few seconds the coffee starts to
brew. When the desired amount of coffee has been delivered, lower the
group lever.
Boiler temperature adjustment
Boiler temperature management is by means of a specific PID; for the settings,
see “THERMOPID SETTING AND FUNCTIONING for CAROLA model”.
To Next Page
Loading...
Need help?
General
