21
Commissioning
1. Lift the tank lid (m) and fill the tank (n) with water, (drinking water, softened
if possible).
2. Connect the machine to an electric socket. Switch on the machine through
the general switch (o) in postion 1 and wait for the machine to fill the boiler
and reach the functioning temperature: the red heating light (q)is to switch
on, then off.
When used for the first time, with the machine warmed, allow an outflow of
approx.0,5 litres of water to flush the coffee delivery group and hot water to
flush the hydraulic circuit.
Coffee brew
1. Remove the filter holder (c) from its seat, turning it clockwise.
2. Fill the filter with one or two doses of coffee (according to the filter
inserted).
3. Press the coffee with the presser.
4. Place the filter holder (c) to its seat, turning it anti-clockwise.
5. Place the cups under the corresponding outlets under the filter holder.
6. Press the key of the required dose (as described in the section “Functions
and adjustments”). With the exception of the continuous dose, the delivery
will stop automatically according to the programming set in the factory, or
that of the customer.
It is recommended to be very careful of the machine hot parts, especially the
delivery group and the steam pipe. Never place the hands under the steam pipe
and/or the group when carrying out the relevant operations.
To Next Page
Loading...
Need help?
General
