52
4. Wait until the machine reaches the working temperature indicated by the
orange light that switches off (m) and the boiler gauge pointer (h)
that is to indicate a value between 1 Bar and 1,5 Bar.
When used for the first time, with the machine warmed, allow an
outlow of approx.0,5 litres of water to flush the group activating
the coffee delivery.
Coffee brew
1. Remove the filter holder (c) from its seat, turning it clockwise.
2. Fill the filter with one or two doses of coffee (according to the filter
inserted).
3. Press the coffee with the presser.
4. Place the filter holder (c) to its seat, turning it anti-clockwise.
5. Place the cups under the corresponding outlets under the filter holder.
6. Lift the coffee delivery lever (b) to the horizontal position to start the coffee
brew, and after a few seconds the coffee brew starts.
When the desired amount of coffee has been delivered, lower the group
lever to the vertical position.
Steam delivery
1. Wait until the heating light (m) switches off (l) and make sure that
the pressure indicated on the boiler gauge is over 0.8 Bar.
2. Open the steam valve (d) for a few seconds and discharge a little steam
into the drip tray (i) then immerse the steam wand (e) in the liquid to be
heated and open the tap, when the required temperature is reached, close
the tap.
After heating the beverage, always discharge a little steam from
the wand to clean the spray holes.
To Next Page
Loading...
Need help?
General
