12.Installation and Disassembly of Nozzle
1) Installation: Insert the selected nozzle into the air outlet steel pipe of
the handle, and then press the air nozzle into the air outlet steel pipe by
hand, and make sure that the air nozzle has been clamped before use.
2) Removing: When disassembling the air nozzle, remove the handle
from the air gun stand. There is a card slot between the air nozzle and the
steel pipe of the air outlet. Put the handle on the air nozzle removal plate
through the clamping groove, fix the air gun stand with one hand, and
then gently pull the handle back to take out the nozzle.
Note:Air nozzle can be customized
Replace the air nozzle after cooling down to avoid scalding.
To Next Page
Loading...