Quick 969D+ - Password Setting; Enter the old password

6
2) After selecting the temperature point, press"
▲
" or "
▼
" to set the temperature of
the temperature point. To save the setting temperature of the temperature point, hold
down the “*” key until " " is displayed in the window.
3) Temperature cannot be set in password locking state, but the three temperatures
can be selected freely. After entering the temperature setting state, press the
“
*
”
and select the one temperature you need.
8. Password Setting
Enter the password setting state
1)Turn off the power switch. Press and hold the “▲”and“▼ buttons
simultaneously, then turn on the power switch.
2)Continue holding down the “▲”and“▼”button until the display shows .
3)When the display shows ,the station is in parameter input mode.
Enter the old password
1)Press the “*” button,, the window will display “---”, the 100’s digit will flash,
initial password can be inputted.
2)Input password: Click the “▲”or“

”button to input the 100’s digit, and then click
the “*” button when displaying the selected value of 100’s digit. After that it comes
into 10’s digit input. The inputting methods of the 10’s digit and 1’s digit are same
with the 100’s digit.