Quickie F35 R2 Rev.E 33
17.0 Performance checks:
After performing any maintenance or repairs on the
wheelchair you must make sure that it is functioning
correctly before it is used.
• Visually inspect the wheelchair to make sure the
legrests, armrests etc are correctly positioned and
attached to the wheelchair and all fasteners are
sufficiently tightened.
• Make sure that the backrest is correctly fitted and
adjusted.
• Make sure that all of the cushions are in place.
• Switch on the hand control – Do the lights flash? This
signifies that there is a fault in the electronic system.
Refer to section 8.0 for basic troubleshooting.
• Perform the parking brake check.
• Drive the wheelchair in each of the drive profiles, (if
installed), to make sure the wheelchair performs as it
did before.
WARNING!
If you are in any doubt about the performance
requirements of your wheelchair contact your Sunrise
Medical authorised dealer.
NOTE: Only the tasks in the GREEN boxes below should
be attempted by the user. If you are in any doubt, please
contact your Sunrise Medical authorised dealer.
Maintenance and Inspection Schedule
Daily
Weekly
Quarterly
Six month
Annually
Check battery level indicator and charge if necessary.
¯
Check the joystick of the hand control is not bent or damaged.
¯
Ensure all removable parts are securely fastened.
¯
Parking brake test.
¯
Check tyres and inflate.
¯
Ensure the fasteners on the seat depth adjustment are tight,
¯
Ensure all cables and connectors are sound and are tidy and out of the way.
¯
Clean wheelchair and upholstery.
¯
Battery terminal inspection – Remove any corrosion and apply Vaseline.
¯
Check upholstery, seating, headrests, armpads and calfpads for wear.
¯
Complete inspection, safety check and service should be made by a
Sunrise Medical authorised dealer.
¯
To Next Page
Loading...
