Quickie Rumba - 5.9 Back Brace Attachment (Rumba); 5.10 Back Brace Attachment (Rumba Modular); 5.11 Crutch Holder Installation and Use

Quickie Rumba 21
Ref: P19093
5.9 Back Brace, Rumba:
Remove the back brace for folding simply squeeze the
levers on both ends and pull towards you, (Fig.5.17).
5.10 Back Brace, Rumba Modular:
Remove the back brace for folding simply depress the
buttons on both ends and pull towards you, (Fig.5.18).
5.11 Crutch Holder, Rumba & Rumba Modular
(Fig.5.19):
WARNING!
Ensure that the crutch is securely fastened to the •
crutch holder.
Ensure that the crutch is not interfering with the •
mechanisms of the chair.
Ensure that the crutch does not protrude from the •
chair.
Do not attempt to remove the crutch whilst the chair •
is in motion.
Always come to a complete stop and turn off the power •
to the controls before attempting to remove the crutch.
This will avoid accidentally operating the chair.
Note: The crutch holder is not available with power or gas
reclining backrest (Rumba Modular only).
Fig.5.19
Fig.5.17
Fig.5.18