QuickJack™ Portable Car Jack 16 P/N 5900263 — Rev. B6 —September 2023
Unpacking
Open the boxes and arrange the QuickJack components where you will be setting them up.
The components needed to set up a QuickJack:
• Box 1. Includes the Left Frame.
• Box 2. Includes the Right Frame.
• Box 3. Includes the Power Unit (operating voltage chosen at time of purchase), Parts Bag,
Hydraulic Hoses, 4 Medium Lifting Blocks, and 4 Tall Lifting Blocks.
⚠ WARNING Your two QuickJack Frames are similar, but they are not interchangeable. Always
line up the Frames parallel to each other as much as the Lifting Points will allow,
with the Lock Bars on the outside, as shown below.
⚠ CAUTION Be sure to route the Short Hydraulic Hoses under the QuickJack Frames. If they
are routed over the QuickJack Frames, the QuickJack will not work correctly, and
the Hoses could be damaged.
3
Checklist
To Next Page
Loading...
