Quicksilver 675 Pilothouse - Page 36

Quicksilver 675PH — System & Component Overview and Operaon
24
Raw Water Washdown Operaon
Before operang the system, make sure that the livewell / raw water pickup valve is in the open
posion. To operate, press the switch marked “RAW WATER WASHDOWN” on the switch panel
located on the a port side of the boat under the gunnel cap. This acvates a 4.0 GPM pump that
supplies water to the washdown sprayer.
Maintenance
Maintenance of the livewell and raw water washdown system will require you to check the ngs
and hoses to make sure that there are no leaks. Check the in-line strainer aached to the pump and
clean if necessary. If the system does require maintenance, contact your local dealer.
If you are storing the boat during the winter, we recommend you winterize the system.
To Winterize the Livewell & Raw Water Washdown System:
1. Drain the water out of all of the hoses in the livewell / raw water washdown system.
2. Remove the sprayer from the raw water washdown hose and drain the water out of the hose.
Livewell—Raw Water Washdown
Livewell/ raw water pickup valve
Livewell pump
Livewell tub
Livewell drain tube
Livewell drain thru hull
Raw water pump
In-line water lter
Raw water sprayer hose
Vented loop
Aerator
Livewell / raw water panel
Access door