23
Quicksilver 675PH — System & Component Overview and Operaon
automacally by a built in mercury free oat switch when the water in the bilge reaches a
predetermined level. You can also manually operate the bilge pump at the console by pressing the
bilge pump switch.
Inspect the bilge pump intake and keep it free of dirt or material which may impede the ow of water
through the pump. To clean the pump strainer, depress the lock tabs on both sides of the pump and
li the pump motor.
If water does not come out of the discharge hose:
1. Remove the motor module to see if the impeller rotates with the power on.
2. Remove any debris that may have accumulated in the nozzle secon or strainer base.
3. Check hose and connecon on hull side for debris and proper connecons.
Check the funcon of all bilge pumps at regular intervals.
Clear pump inlet from debris.
The bilge pumping system is not designed for damage
control.
Bilge pump
Bilge pump hose
Thru hull
Typical Bilge Pump System
5. Livewell / Raw Water Washdown (oponal)
An oponal livewell and raw water washdown system is available for this boat. If installed, both the
40 liter livewell and the raw water washdown are located on the port a side of the cockpit. The
livewell is used to keep baiish alive by circulang seawater through the tank.
Livewell Operaon
Before operang the system, make sure that the livewell / raw water pickup valve is in the open
posion. The livewell / raw water pickup valve can be accessed through the motorwell access plate.
To ll the livewell, press the switch marked “LIVEWELL” on the sh pack switch panel located under
the port coaming cap. Inside the livewell, there is an aerator spray head that allows you to control the
ow of water. To increase the ow of water, turn the spray head counterclockwise, while turning the
valve clockwise decreases the ow. Located in the center of the livewell, there is a drain tube which
allows excess water to ow overboard, and fresh seawater to connually circulate. To drain the
livewell, simply unscrew the drain tube.