SX0011.C 141 SX0011.C
P O R
I T A
E N G E S P
The panel shows 7 stages of battery level.
When the indicator shows the 5 bars, the battery is full of charge.
When the indicator shows any bar, then the battery has no charge. If the indicator flicks, then the level of charge is critic.
2.8. Power indicator
The power given by the motor is always shown on the low and right side
of the screen.
2.9. Error messages
In case that an error occurs, the bicycle will not work and an error code
will be shown on the low and right side of the panel. Errors must be
subsanated, otherwise, the bicycle will not work correctly. Error
messages correspond to these phenomenons:
06 ʹ Too low voltage protection
07 ʹ Too high voltage protection
08 - Sensors Hall error
09 - Error of phase of Motor
10 ʹ Control unit overheating
11 ʹ Temperature sensor in Control Unit
12 ʹ Intensity sensor
13 ʹ Motor overheating
14 ʹ Error of the Temperature sensor of the Motor
21 - Error of the velocity sensor of the Motor
22- Communication error in BMS
23 ʹ Front light error
24 - Error of the front light sensor
30 ʹ System communication Error
3. CONFIGURATION AND ADJUSTMENTS
De serie la bicicleta eléctrica incorpora la Configuración Por Defecto. In order to Access to the configuration meu, with
the panel on, press and keep pressed the buttons [ + ] and [ - ] at the same time:
3.1. 1 SET: Setting up TRIP and TRIP TIME
TC: "Trip Clearance" shows two options TC-n: does NOT
set to 0 and TC-y: dos YES set to 0. Changes are done
with the buttons [ + ] and [ - ].
Press the button [M] to save and go on or keep it pressed
to save and escape.
3.2. 2 SET: Screen bright level
BL: Back Light. It has three options of screen light bL-1, bL-2 y bL-3.
Select the desired one with the buttons [ + ] and [ - ].
Press the button [M] to save and go on or keep it pressed to save
and escape.
3.3. 3 SET: Wheel size
To Next Page
Loading...