SX0011.C 191 SX0011.C
CHARGER
I T A
E N G
E S P
P O R
Do not exceed the standard capacity (voltage/electricity) of a multiple power point or an electrical extension when is
being used with the product, as there is risk of electrical shock.
The charger has been designed to be used with an disconnectable power supply cable that will be used in a current
power point. The power unit is able to work with different voltages without the need of any user adjustments.
If the power supply cable or the power point makes noise, disconnect the cable from the power point and contact an
official dealer. There might be risk of electrical shock.
If you see that the charger is damaged, contact an official dealer or contact us at
www.quipplan-mobility.com . For
throwing it away, do never throw it into the dustbin
Do not use a principal power point, a power supply cable or a power point when it is loose or damaged, as there is
conflagration and electrical shock risk.
Connect the power supply cable to a power point and then to the charger. If this is not done, it might cause a
conflagration
Do not disconnect the power supply cable by pulling it out. If the cable is damaged, this might cause an electrical
discharge.
Do not over bend the power supply cable and do not place a heavy object on it.
Keep the power supply cable away from children and pets. If the cable is damaged, it might cause an electrical
discharge.
3. INSTRUCTIONS FOR USE
For a correct use of your charger, please follow these steps:
3.1. Connect the charger to the power point. The light of the charger
will turn Green, which means that the charger works correctly.
3.2. Connect the charger to the battery. The light of the charger will be read during the charging period. Remember
that the battery can be charged inside the bicycle, through the charging point located in the right side of the frame, o r
out of the bicycle.
ó
3.3. When the battery is completely charged, the light from the charger will turn Green, as in the
beginning
3.4. For disconnecting the charger, first do it from the battery and then from the power point.
To Next Page
Loading...