QUNDIS Q node 5.5 User Manual

V1.0 / 31.01.2019 FUM5-00AM-DES-N5550 19
Operating and Installation Instructions Q node 5 - en
Error codes
$Q[RQHUURUOHYHOEDQG&GHVFULEHV KRZRIWHQWKLVHUURUKDV
RFFXUUHG,IDJURXSHUURURFFXUVPRUHRIWHQWKDQWLPHVDOLQH
is shown here.
Device itself
EA10 *HQHUDOGHYLFHHUURU
EA11 +DUGZDUHHUURU
EA12 Memory error/loss of data
EA20 3DUDPHWHUVRXWVLGHWKHWROHUDQFHOLPLW
EA21 Main battery low
EA22 Backup battery low
EA30 Tolerance error of another system device
EA31 3ULPDU\DGGUHVVFRQÀLFWDGGUHVVDVVLJQHGWZLFH
EA32 Message decryption failed
($ Device not compatible
EA38 Clock error
Other network
nodes
(E[ 'HYLFHHUURUKDUGZDUHRUPHPRU\
(E[ Battery too low or device outside tolerance
(E[ Errors 1 and 2 occurred
(E[ Communication to network interrupted
(E[ (UURUVDQGRFFXUUHG
(E[ (UURUVDQGRFFXUUHG
(E[ (UURUVDQGRFFXUUHG
Metering devices
(&[ 'HYLFHHUURUKDUGZDUHRUPHPRU\
(&[ Battery too low or device outside tolerance
(&[ Errors 1 and 2 occurred
(&[ Communication to metering devices interrupted
(&[ (UURUVDQGRFFXUUHG
(&[ (UURUVDQGRFFXUUHG
(&[ (UURUVDQGRFFXUUHG
IrDA-Master mode
Err1 Device is not supported
Err2 Device is not accepted
- Lists are full e.g. more than 500 metering devices
- ([WHUQDOGHYLFHVXSSO\LQJIDOVHGDWDRUHUURU
Err3 Authorisation has failed.
- ([WHUQDOGHYLFHZDLWLQJIRUFRUUHFWORJLQDQGSDVVZRUG
(UU Break in communication
- Connection interrupted before end of communication
Err5 :URQJFRQ¿JXUDWLRQ
- Node still in idle mode
- 3XOVHDGDSWHUQRWSDUDPHWHULVHG
- ([WHUQDOQHWZRUNQRGHVQRWLQLGOHPRGH
Acknowledging errors
$IWHUHUURUVKDYHEHHQQRWHGWKH\FDQEHGHOHWHGE\DFNQRZOHGJLQJ
WKHHUURUPHVVDJHV7RGRWKLVFKDQJHWRWKHGLVSOD\OHYHO³(´E\
SUHVVLQJWKHEOXH',63/$<NH\UHSHDWHGO\:KHQWKH',63/$<NH\
LVNHSWSUHVVHGIRUPRUHWKDQWZRVHFRQGVDOOWKHHUURUVRQWKH³($´
OHYHODUHGHOHWHG,IWKHHUURUVWDWHRFFXUVDJDLQWKHHUURUFRGHZLOO
reappear on the display
Installation instructions
Installation location
The network nodes Q node 5.5 have only been designed for applications
inside buildings. The type plate is on the inside of the device cover.
Measures to avoid problems
Install the network node in a frost-free environment and not close to
high-voltage cables or electrical systems or on metallic or conduc-
tive surfaces.
Silicone must not be used as an adhesive for gluing the Q node 5.5 in
SODFH,IVLOLFRQHLVXVHGDVDQDGKHVLYHIRUWLOHVHWF\RXPXVWZDLW
IRUDWOHDVWKRXUVDIWHUWKHXVHRIWKHVLOLFRQHEHIRUHWKH4QRGH
may be installed.
Mechanical attachment Q node 5.5
7KH4QRGHPXVWEH¿[HGWRWKHZDOOXVLQJWZRVFUHZV)RUWKLVSXU-
SRVHWZRKROHVZLWKDGLDPHWHURIPPPXVWEHGULOOHGPP
apart. Screws and dowels are included in the scope of supply.
Electrical installation RNN5 000M 1x
After the housing is opened, certain parts of this device
become accessible which can be under hazardous volt-
age.
During all work on the Q node 5.5 the device must be discon-
nected from the mains.
• The device is not equipped with an isolating device. For this rea-
VRQ WKHUH PXVW DQ HDVLO\ DFFHVVLEOH LVRODWLQJ GHYLFH DYDLODEOH
outside the equipment.
• 2QO\ TXDOL¿HG HOHFWULFLDQV PD\ FDUU\ RXW ZRUN RQ WKH GHYLFH LQ
compliance with the electrical engineering regulations in accord-
ance with the type of use.
• 7KHSHUVRQQHOPXVWEHIDPLOLDUZLWKDOOWKHVRXUFHVRIKD]DUGDQG
maintenance measures in accordance with the regulations speci-
¿HGLQWKHVHLQVWUXFWLRQV
Non-observance of these warnings can lead to physical inju-
ries and property damage.
• Insert the cable gland included into the through bore of the
housing.
• Tighten the counternut of the cable gland.
• Insert the cable.
• &RQQHFWWKHFDEOHZLUHVLQDFFRUGDQFHZLWKWKH³PDLQVSRZHU
FRQQHFWLRQ´GLDJUDP
• )L[WKHFDSQXWRIWKHFDEOHJODQG
0DLQVSRZHUFRQQHFWLRQ&DEOHW\SH1<0-[PP
2
6 mmPP
N
L
ѥ
Installation RS232 RNN5 000M 1x
Connect the cable of the RS232 connection to the RS232 interface
RIWKH5110[3OHDVHQRWHWKDWGDWDDUHUHFHLYHGYLDWKH
TX connection and transmitted via the RX connection (see arrows
RQWKH56LQWHUIDFH
2QWKHRSSRVLWHVLGHWKHFRUUHVSRQGLQJDVVLJQPHQWLVDVIROORZV
ZKHQDSROH'6XEEXVKLQJLVXVHGIRUH[DPSOH
5110[ D-Sub connector 9-pin female
*1' 3LQ
RX 3LQ
TX 3LQ
7KH VWDQGDUG %DXG UDWH LV  %DXG ,I QHFHVVDU\ LW FDQ EH
FKDQJHGXVLQJWKH481',6DSSOLFDWLRQ$&7ZKLFKFDQEHGRZQ-
ORDGHGIURPWKH481',6'RZQORDG&HQWHUVHHKWWSTGFTXQGLV
com/
Commissioning RNN5 000M 0x
)RUVDIHW\UHDVRQVWKH4QRGHLV
not delivered with the main bat-
tery connected.
3OXJFRQQHFWRUIRUYROWDJH
supply DC 3.6 V
3OXJFRQQHFWRUIRUEDFNXS
battery
0DLQEDWWHU\
%DFNXSEDWWHU\

QUNDIS Q node 5.5 Specifications

General

Brand	QUNDIS
Model	Q node 5.5
Category	Gateway
Language	English