R.E Prescott Bubble-Up Jr Interactive - System Controls and Indicators; Bypass Valve Operation; Meter Control Manual Reference; Mechanical Pump Control Manual Reference

Bubble‐Up®JrInteractive™RadonRemovalSystem
7
ControlsandIndicators

Bypassvalve
ThisvalvecanbeusedtodivertthewaterflowifaproblemdevelopswiththeBubble‐Up®JrInteractive ™unit.
Thisvalvehastworedhandles,andislocatednearthebackoftheunit.SeeFigure7.Thevalvehastwopositions:

• Service‐Thisis
thenormaloperatingposition.Whenthetwovalvehandlesareinlinewithwaterflow,theunit
canremoveradonfromtheincomingwater.
• Bypass‐Whenthetwovalvehandlesareperpendiculartowaterflow,theincomingwater“bypasses”the
Bubble‐Up®JrInteractive™unit.Usethispositiononly
ifthereisaproblemwiththeunit.

Caution!WhenthebypassvalvesaresettotheBypassposition,theBubble‐Up®JrInteractive™unitcannotprovideany
protectionagainstradoninthewater.

MeterControl
ForinstructionsregardingthemetercontrolrefertotheBubble‐UpMeterControlmanual
intheappendixandonlineat
www.represcott.com

MechanicalPumpControl
ForinstructionsregardingthemechanicalpumpcontrolrefertotheBubble‐UpMechanicalPumpControlAssembly
Owner’sManualintheappendixandonlineatwww.represcott.com.

WaterAlarmValve
Thewateralarmvalvecontrolisdesignedtoidentifyleakingproblemsin
theBubble‐Up®JrInteractive™.Itisdesigned
tomonitorradonventobstruction,highwaterandfittingleaks.Itdoesthisbyincorporatingawateralarmvalvefloat
switch,wateralarmfloorsensorandwateralarmtanktopterminal blocksensortosignalthewateralarmvalvecontrol
whichoperates
themotorizedwateralarmballvalve.Seefigures13and14.

ImportantFeature:Thewateralarmvalvecanalsobeusedtocreateanynumberofremoteleakdetectionpointsby
connectingextraleadstotheleadsoftheterminalblock.

UsersGuide:
 Pleasechoosethecorrectmodeon
themodeswitchshowninthepictureaccordingtotheapplication.Inthe
caseoftheBubble‐Up®JrInteractive™,theswitchshouldbeinthenormalwaterposition.Seefigure5*
 Thebuzzerwillbeepifthereisaradonventpipeobstruction,highwateralarmordetectedwater
leak,andat
thesametimeasignalwillbesenttotheexternalmotorizedballvalve.Thissignalwillcausetheballvalveto
closeandcutoffthewatersupplyimmediately.
 Toresetthemotorizedballvalvetoitsoriginalopenposition,holdtheresetbuttonfor
threeseconds.
 Ayellowlightaccompaniedbythebuzzermeansthatthebatteryislow.Ifthisoccursreplacethebatteryas
soonaspossibletoavoidanyoverflowsduringapoweroutage.

ImportantinformationabouttheWaterAlarmValve:Thealarmonthiscontrolwillgooffif
thereiswaterinsideofthe
control.Ifthisoccurs,fullydrytheinsideofthecontrolbeforereturningittoservice.





