R82 Rabbit - HINGED KNEE SUPPORTS

12
A
C
D
E
B
A
A
B
G
B
GB
HINGED KNEE
SUPPORTS
Follow the description below to mount the hin-
ged knee supports correctly. The knee supports
are mounted seperately and can be adjusted
individually.
* The square plates on the knee support is
mounted in the slot on the centre bar.
* Adjust the knee support in to the desired
height and fasten (A) using the enclosed 6
mm allen key.
Make sure that the fitting (B) is in vertical
position when the knee support is mounted.
(not for size 1).
* Loosen the screw (C) and adjust the angle of the
foot support. Fasten in the desired position.
* Loosen the screw (D) to angle the support
around the knee. Use the enclosed 5 mm
allen key.
* Loosen the screw (E) and adjust the knee
supports sidewise.
EXTRA CUSHION
Move the cushions on the chest support or the
hip support to the side by loosening the bolts (A)
and make room for the extra cushion.
Place the extra cushion in the middle between
the cushions, and tighten the bolts (A) and (B).
Can be mounted on the chest support and
hip supports size 2 and 3.
GB