R82 Rabbit - HEAD SUPPORT

15
F
H
G
A
B
C
D
E
G
B
HEAD SUPPORT
Follow the description below to mount the head
support correctly.
Either back support or hip supports (rear)
must be mounted to be able to mount a
head support on the Toucan
* Mount the head support bar on the fitting
from the back support/hip supports (rear) and
fasten with the enclosed 4 mm Allen key (A).
* Loosen the handle (B) to adjust the angle of
the head support bar.
* Loosen the handle (C) to adjust the height of
the head support.
* When a lower setting of the head support is
needed, the fitting on the back- / hipsupport
can be replaced with a new fitting and bar (D).
* Loosen the screw (E) to adjust the angle of
the head support bar.
* Use the enclosed 5 mm Allen key to loosen
the screws (F) and adjust the head support.
Loosen the screw (G) to angle the head sup-
port. Loosen the screw (H) to adjust the head
support sidewise.
GB