22
G
B
CARE AND MAINTENANCE
PUR
All parts made of PU material must be wiped off with a cloth frequently.
WHEELS/BRAKES
Ball bearings: The ball bearings require no maintenance. Clean the wheels frequently to make
them run more smoothly and make the brakes function optimally. NO lubricating oil is required
around the brakes. Wheels that are worn out must be replaced.
Check the tyres regularly for air. Air presure: 110 PSI/7,5 bar/750 kPa - 36 PSI/3,5 bar/350 kPa.
SPOKES
Regularly the spokes need to be adjusted by an expert. For instance by your local bicycle engi-
neer.
HAND RIMS
If a handrim should be damaged in such a way that it could lead to hand injury, it should be re-
placed.
FRAME
Tighten all screws on the frame on a regular basis, especially when the Rabbit has been adjusted.
Also, it is important to keep the frame clean, both for the users comfort and the longevity of the
standing frame. Wash the frame with car shampoo or dishwashing liquid. Do not use any cleaning
materials containing chlorine or methylated spirit.
If the Rabbit is especially dirty, a grease remover may be used.
INSPECTION
It is important to tighten all screws on the standing frame on a regular basis. All screws which
secure the accessories must be checked, at least once a month. To avoid sharp edges, it is
important to check all rail-ends have end caps. Also, it is important to be aware of any cracks or
faults in the frame, PVC parts, etc.
REPAIR
If there is a problem with your Rabbit you should contact your dealer at once. Defective
frames should not be used. If your standing frame need reconditioning or repair, only original
R82 parts may be used. Accessories or available spare parts which are broken can be forward-
ed to R82 for repair. If there is a problem with any basic parts, the whole frame must be returned
to R82 for repair. R82 will not be held responsible for damage or injury caused by use of non-
original parts or repairs made by a non-authorised R82 person.
GB
To Next Page
Loading...
