Rabbit Air A3 - Replacing the Filters

22 Rabbit Air - 23
Replacing the Filters
Always power o the unit before cleaning/replacing the lters.
Depending on your indoor environment, the lifespan of the lters may
vary. The lter light will illuminate red for cleaning/maintenance while
a blinking red light means that it is time to change lters. Plug the unit
back in to reset the lter indicator.
Filters
Pre-Filter
Medium
Charcoal-Based Activated Carbon
BioGS HEPA
Customized
Filter Life*
Washable
Every 12 months
Every 12 Months
Every 12 Months
Every 12 Months
Cleaning
Every 3 months
Not Required
Not Required
Not Required
Not Required
*based on 24/7 operation
Filter Maintenance Schedule
Discarding
Used Filters
1. Grab the handles at the center of the
top and bottom of the Filter Case.
2. Push together and pull the entire case
out of the air purier.
3. Once you have removed the Filter Case,
lay it on a at surface.
4. Remove the Pre-Filter by pinching the
two tabs on the top left and right side
of the frame.
Do NOT discard the Pre-Filter. It is
designed to be cleaned and reused.
5. Discard the remaining lters inside.
Filters should fall out easily by ipping
over the Filter Case.
6. Set aside your Filter Case and Pre-Filter.