EasyManua.ls Logo

Race Navigator ONE - Getting Started with Race Navigator ONE; Powering On the Device; Powering Off the Device

Default Icon
43 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
!
!
Delivery scope
Take the Race Navigator ONE out of
the box and check the box’s content:
Race Navigator ONE
External GPS antenna
12 V car adapter cable and 230 V
charger
Holder (optional)
The RN ONE’s battery is pre-charged
so you can start using the device
immediately.
Installation
Take the holder and screw it to the RN
ONE. In the vehicle, put the sucker of
the holder below the rear-view mirror
and fasten it tight to the windscreen
with the clamping lever.
Make sure whether the mounted RN
ONE can record videos properly. In
general, the best position is about
510cm above the dashboard.
Adjust the RN ONE so that the top is
approximately in balance.! Check the
position by recording a test video.
NOTE: Before every ride, check the
adherence of the holder. Incorrectly
installed device might get detached
from the windscreen and get damaged,
cause damage to the car, or serious
injuries to the driver.
Turning on
Turn the RN ONE on by pressing the
Home button for at least 3 s. The
system starts up and the Home screen
is displayed.
Turning off
Turn off the RN ONE by pressing the
Home button for at least 7s. In the next
dialog, click YES to confirm or NO to
abort the operation.