Need help?Do you have a question about the Race Navigator ONE and is the answer not in the manual?
General| Data Logging | Yes |
|---|---|
| GPS | Yes |
| Camera | No |
| Battery Life | Up to 4 hours |
| Connectivity | Bluetooth |
| Expandability | SD card slot |
| Update Method | USB, SD card |
| Mounting Type | Suction cup mount |
Procedure for turning on the Race Navigator ONE.
Procedure for turning off the Race Navigator ONE.
Accesses the main data display panels of the device.
Analyze recorded lap data directly on the device.
Configure device and system parameters.
Explains the icons displayed in the top status bar.
Describes the three main data display panels.
Shows time gap between current and reference laps.
Visualizes lap time differences over the last 20 seconds.
Allows choosing a different lap as a reference.
Displays laps from the current event with color coding.
Shows diagnostic data from the vehicle via OBD-II.
Notes the need for RN PLUG and USB Bluetooth RN Stick.
Select two laps for side-by-side comparison.
View speed series charts for selected laps.
Configure Wi-Fi and analyzer mode connections.
Steps to record and save a new track route.
Special mode for endurance events, immediate data transfer.
Special mode for taxi events with immediate data transfer.
Set up an access point for iPad analysis.
Connect to Wi-Fi networks for updates and internet access.
Install the latest version of the device software.
Reset device settings to factory defaults or specific states.
Displays battery level and GPS signal strength.
Steps to start the update process from settings.
Process of downloading the latest software version.
Installing the downloaded software version.
Activating the installation after download.
Monitoring the installation of new software packages.
Confirmation of successful installation and device restart.
Resetting device settings to factory defaults.
Restoring device software to original settings.
Performing device recovery to basic installation.
To Next Page