RaceChip RS - Step 5: Connecting the RaceChip and first function test

C
3 Installation
1
2
3
Step 5 of 7 – Connecting the RaceChip and fi rst function test
Disconnect the deactivation plug
from the wiring harness
Connect the RaceChip
• If the green LED lights up immediately after connecting the RaceChip, it means there
was still power in the system during installation.
• 
refer to Trouble Shooting for a solution.
Carrying out function test
• C
anything in place yet.
• Switch the ignition on. DO NOT start the engine.
• Check for the following:
- Control lights on the dashboard light up and go out as normal.
TONCOverview of the RaceChip).
• If all the above happens, you can start the engine. It should start as normal and
should react to the throttle when idling.
• Switch off the engine and ignition.
• If your car will not start as normal, please refer to Trouble Shooting for hints and tips.
• Our Customer Service is of course always ready to help. See Contact for details.