Raddy L7 - 3.3 Sensor Assembly Set Up

- 6 -
3.2 Recommend Tools
●
Precision screwdriver (for small Phillips screws)
●
Compass or GPS (for wind direction calibration)
●
Adjustable Wrench
3.3 Sensor Assembly Set Up
Note: The outdoor sensor array must be powered and
updating before powering up the console, or the console will
stop scanning and connecting with the sensors.
The following illustration shows the full segment of integrated
outdoor sensor including Thermo-Hygrometer, Wind, Rain, UV
and Sunlight sensor, as shown in Figure 2.
3.3.1 Install Integrated Outdoor Sensor Battery.
Figure 2