Raddy PT-3 Manual [EN]
After close the lid, a tether can be added into the key hole.
This pairing mode only takes 3 minutes, if the pairing fails after more than 3 minutes, you need to press and
hold the “CH” button for 2 seconds to re-enter 3 minutes pairing mode.
After successful pairing, the remote sensor can be put into the swimming pool to detect its water
temperature.
When using the wrenches, the side with the arrow symbol should face upwards.
The small wrench and the lower cover must be fixed in a tight direction.
The big wrench and the upper cover must match tightly, especially the arrow positioning.
To Next Page
Loading...