Radenso XP - Mute Mode Operation; Laser and Radar Alert Displays

=============================================================================
Mute Mode
=============================================================================
Pressing the MUTE button during an alert will temporarily mute the detected signal and will automatically unmute
20 seconds after the signal has passed or if a new and/or different signal has been detected.
Pressing the MUTE button without the presence of an alert will permanently mute the detector on X and K band
until either manually unmuted or after a new power-up cycle. Ka band Laser will NOT be muted in this Mode.
=============================================================================
Laser / Radar Alert
=============================================================================
1. Display for Laser/Radar Alert
1.1. Laser
1.2. X Band
1.2.1. Standard
1.2.2. Frequency
1.3. K Band
1.3.1. Standard
1.3.2. Frequency
1.4. Ka Band
1.4.1. Standard
1.4.2. Frequency