10
Specifications
Frequency Coverage (MHz):
Channel 1 .............................................................................162.400
Channel 2 .............................................................................162.425
Channel 3 .............................................................................162.450
Channel 4 .............................................................................162.475
Channel 5 .............................................................................162.500
Channel 6 .............................................................................162.525
Channel 7 .............................................................................162.550
Receiving Sensitivity (at 12 dB SINAD) ................................ 0.6µ V
Signal-to-Noise Ratio .............................................................40 dB
Audio Output Power:
Maximum .............................................................................250 mW
At 10% THD ..........................................................................200mW
Channel Selectivity ..................................................±25KHz, 40 dB
Power Supply .............................................6V DC 300mA Adapter
................................................................ DC 6V battery for backup
Antenna .................................................Telescoping Rod Antenna
Dimensions (HDW) .............1.4×4.6×5.5 in (35.1×117.5×140 mm)
Weight (no battery) ..................................................... 8.8 oz (250g)
Specifications are subject to change and improvement without notice.
Actual product may vary from the images found in this document.
FCC Information
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installa-
tion. This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
To Next Page
Loading...
Need help?
General
