8
4. Press or hold down ) or ( to set the hour.
5. Press SET to confirm. The minute digits flash.
6. Press or hold down ) or ( to set the clock
minutes.
7. Press SET to confirm. % and the current signal loss
reminder setting (On or OFF) appear.
8. Hold down SET to return to the normal display.
Or, press SET to enable or disable the signal loss
reminder (proceed to step 4 in the next section).
Enable/Disable the Signal Loss Reminder
1. Hold down SET until you hear a beep. CH 1-7 (current
channel number) flashes.
2. Press ) three times. The current setting (On or OFF)
and % appear.
3. Press SET. % flashes.
4. Press ) or ( to toggle between On and OFF.
5. Press SET to confirm. CH and the current channel
number flash.
6. Hold down SET to return to the normal display, or
press SET once to return to channel setting mode.
Enable/Disable the Alarm
1. Slide ALARM to ON or SNOOZE to enable the
alarm. É appears.
2. The alarm sounds at the preset alarm time, becoming
progressively louder.
3. To snooze, press WEATHER/SNOOZE. The alarm
stops for 10 minutes. After 10 minutes, the alarm
sounds again until you slide ALARM to OFF to turn it
off.
To Next Page
Loading...
Need help?
General
