21
Settings
To remove the lockout from a channel, manually select the channel, then
press L/O. L/O disappears.
To unlock all channels in the selected banks, press SCAN/MAN to stop
scanning, then hold down L/O until the scanner beeps twice.
Setting Priority
The priority feature lets you scan through the channels and still not miss
important or interesting calls on specific channels. You can program one
stored channel in each bank as a priority channel. The scanner checks the
designated priority channel every two seconds in each bank.
Press PRI during scanning to turn the priority feature on and off. Pri ON
appears for several seconds when priority is turned on. And Pri OFF appears
for several seconds when priority is turned off.
BANK0 23 5 789
DLY
Note: If you have locked out all priority channels, All Loc appears
when you activate the priority feature.
The scanner automatically designates each bank’s first channel (Channel 00)
as its priority channel. To select a different channel as the priority channel:
1. From Scan or Manual mode, press ENT/PROGRAM.
2. Press T or S to select the channel you want to set as priority, then press
and hold PRI/WX ALERT until the scanner beeps twice.
Or, enter the bank and channel number you want to set as priority and
then press PRI.
P appears to the left of the selected channel number.
3. Repeat Steps 1 and 2 for the channel in each bank that you want to
program as a priority channel.
Using the Display Backlight
To turn the display backlight on and off, press and hold until the scanner
beeps twice.
To turn on the display backlight for only 15 seconds, press
briefly.
To Next Page
Loading...
