Turning Channel-Storage Banks On and Off
To turn a channel-storage bank on or off, press the bank’s number key (1–0,
using 0 for bank 10) during scanning. The channel-storage banks are on when
they have a bar underneath them and off when no bar appears underneath
them.
n Notes:
• The scanner does not scan any of the channels within the banks you have
turned off.
• You cannot turn off all banks; there must be at least one active bank.
• You can manually select any channel in a bank, even if the bank is turned
off.
• When you turn on a bank during scanning, the scanner moves to the
selected bank and scans it.
• If no transmission is found, the scanner continues to scan through all
selected banks.
Monitoring a Stored Channel
You can continuously monitor a specific channel without scanning. This could
be useful if you hear a transmission on a channel and do not want to miss any
details, even though there might be periods of silence.
1. Press SCAN/MAN until MAN appears.
2. Enter the channel number (1–200).
3. Press SCAN/MAN again.
Clearing a Stored Channel
To remove a frequency stored in a channel.
1. Press SCAN/MAN to stop scanning.
2. Press the number keys to enter the channel number (1–200).
3. Press PGM. PGM appears.
4. Press 0 then ENT. The frequency number changes to 000.0000 to indicate
the channel is cleared.
5. To clear another channel, use the number keys to enter that channel
number then press PGM again. Or, repeatedly press PGM until the desired
channel number appears. Repeat Step 4.
To Next Page
Loading...
Need help?
General
