Basic Operation
Reviewing and Removing Lock-outs
Stored Channels
1. Hold down L/O
/
L/O RV W for about two seconds while in manual
operation. The scanner pulls up a list of locked out channels.
2. Repeatedly press and hold L/O
/
L/O RV W to show the next locked out
channel. If an error beep sounds, there are no locked out channels.
3. To remove the lock-out, press L/O
/
L/O RV W until
L/0
disappears.
Marine Service Bank
1. Press PSE during the Marine Service Bank search.
2. Hold down L/O
/
L/O RV W for about two seconds. The scanner pulls up a
list of locked out channels.
3. Repeatedly press and hold L/O
/
L/O RV W to show the next locked out
channel. If an error beep sounds, there are no locked out channels.
4. To remove the lock-out, press L/O
/
L/O RV W until
L/0
disappears.
Other Service Banks
1. Hold down L/O
/
L/O RV W for about two seconds during a Service Bank
search.
2. Press e or d repeatedly to scroll through the list of locked-out frequencies.
L-r and
L/0
appear in the display.
3. Press L/O
/
L/O RV W to remove the lock-out. The list scrolls to the next
locked-out frequency.
n Notes:
• When you reach the highest locked-out frequency, the scanner beeps twice
and rolls to the lowest locked-out frequency.
• If the Service Bank has no locked-out frequencies, EMPty appears.
Removing Lock-outs from All Frequencies in a Service Bank
1. Hold down L/O
/
L/O RV W for about two seconds during a Service Bank
search. L-r appears.
2. While holding down TUNE/CLEAR, press L/O
/
L/O RV W. FLo ALL–CL
appears for about two seconds. Then the display alternates with YES ---Ent
and No --CLEAr.
3. Press ENT. L-r EMPty appears. The scanner clears lock-outs from all
frequencies in the Service Bank.
To Next Page
Loading...
