10
Setup
Setup
w Caution: A sudden high output from the mixer could damage your hearing
or damage the audio devices connected your mixer. Before connecting to AC
power, turn off your mixer and all audio devices connected to your mixer.
Connecting Outputs
To play the mixer’s output signal through your sound system, connect one end
of an RCA audio cable (not included) to the mixer’s AMP OUTPUT L (white)
and R (red) jacks. Then connect the other end to your receiver/amplifier’s L and
R input jacks, matching L to L and R to R.
If your amplifier or receiver is not equipped with RCA jacks, connect one end
of a ¼ in. (6.35 mm) audio cable to the mixer’s BALANCE OUTPUT L/R jacks.
Then connect the other end to your amplifier or receiver’s input jack.
n Note: Do not connect the ¼ in. (6.35 mm) audio cable and RCA audio cable
simultaneously.
To record the mixer’s output signal, connect one end of an audio patch cord
(not supplied) to the mixer’s REC OUTPUT L (white) and R (red) jacks, then
connect the other end to your recording device’s L and R line input jacks,
matching L to L and R to R.
AMP OUTPUT L/R
BALANCED OUTPUT L/R
REC OUTPUT L/R
To Next Page
Loading...
