Radio Shack 3200026 - Connecting a Lamp; Connecting Headphones; Headphone Volume Control

13
Setup
Connecting a Lamp
Connect a 12V DC/3W BNC lamp (not supplied) to the 12V/3W MAX LAMP
socket so you can see the control panel in dark or low-light conditions.
Connecting Headphones
To listen in privacy or monitor the audio source inputs so you can locate an
exact passage or section before mixing it, connect a pair of stereo headphones
(not supplied) with a ¼ in. (6.35 mm) plug to the PHONES jack.
Do not listen at extremely high volume levels. Extended, high-volume listening
can lead to permanent hearing loss. To protect your hearing when using
headphones, always follow these guidelines to set the listening volume:
•
Set CUE (headphones volume) to minimum before putting on your
headphones.
•
After you put on the headphones, adjust CUE to a comfortable listening
level. Do not increase the CUE setting. Over time, your ears adapt to the
volume level.
12V/3W MAX LAMP
PHONES Jack
CUE