11
Setup
To monitor the mixer output on a second set of speakers, connect one end of
an audio patch cord (not supplied) to the mixer’s BOOTH OUTPUT L (white)
and R (red) jacks. Then connect the other end to your secondary amplifier’s L
and R input jacks, matching L to L and R to R.
Connecting Inputs
You can connect up to eight audio input sources (such as a tuner, cassette
deck, CD player, or VCR) to the input jacks on the back of the mixer.
w Caution: Do not connect an audio source with a line-level to the low-level
PHONO 1 or PHONO 2 audio input jacks.
1. Connect the line-level outputs from up to seven audio sources to the LINE
(1–7) input jacks, matching left to left, and right to right.
n Note: PHONO 1 and LINE 1 (as well as PHONO 2 and LINE 3) use the
same jack. When connecting the line-level output audio sources, slide INPUT
SELECT to LINE 1 and LINE 3.
2. Connect the low-level outputs from up to two audio sources (such as
turntables) to the PHONO 1 and PHONO 2 input jacks.
n Note:
• If you connect magnetic-cartridge turntables, connect their ground wires
(usually black or green) to GROUND.
• To use PHONO 1 and PHONO 2 input jacks, slide INPUT SELECT to
PHONO 1 and PHONO 2.
BOOTH OUTPUT L/R
PHONO 1 and
PHONO 2
GROUND
To Next Page
Loading...
