34 Using Macros
6-IN
-ONE
USING MACROS
MACROS
You ca n p ro g ram your remote to issue a sequence
of commands at the press of one button. For
example, you may want to turn off your TV,VCR,
and Satellite at the same time. Any sequence of
commands you regularly use can be reduced to
one key press for your convenience.A key that is
programmed with a Macro works through all
modes (provided its available in that mode).
Therefore a Macro should only be set on the
Custom keys (M1 – M4).You can install a Macro
on any key, except for the device keys (TV,VCR,
SAT/CBL, CD,AUD, and DVD), P, SCREEN, and
FAV SCAN.
T
OSETUP THE MACRO MENTIONED ABOVE ON THE KEY
LABELED
“M4”ON YOUR REMOTE:
1. Hold down P for at least 3 seconds. The bottom
of the IR Indicator blinks twice, and a circle
appears around P.
2. Press 9 9 5.The bottom ofthe IR Indicator
blinks twice.
3. Press M4.This is where your macro is assigned.
4. Press TV, POWER,VCR,POWER,SAT,
POWER.
5. To store the Macro, hold down P for at least 3
seconds. The bottom of the IR Indicator blinks
twice.Whenever you press the M4 key, the
remote will turn off your TV,VCR,and Satellite.
• EACH MACRO CAN CONSIST OF A MAXIMUM OF 15 KEYSTROKES.
• TOINCLUDE AFUNCTION FROM A PARTICULAR SCREEN IN A MODE, USE
SCREEN.
• M
AKE SURE THAT YOU PROGRAM A
MACRO ON A SPARE KEY THAT YOU
DON
’TUSEINANY MODE.
• M
ACROSPROGRAMMED ON SPECIFIC KEYS WORK REGARDLESS OF THE
MODE (TV,VCR, SAT, C D , AU D , OR DVD). THE FUNCTION ORIGINAL-
LY PROGRAMMED ON THAT SPECIFIC KEY IS OVERWRITTEN WHEN YOU
PROGRAM A MACRO
.
• T
OAVO ID ACCIDENTAL RECORDINGS WITH THE REMOTE
,YOU MUST PRESS
RECORD TWICETOBEGIN RECORDING.IFYOUASSIGNAMACRO ON
RECORD, THE DOUBLE KEY PRESS IS DEACTIVATED.THEREFORE WE
RECOMMEND NOT ASSIGNING A MACRO ON THIS KEY.
• IFYOUHAD TO HOLD DOWN A KEY FOR A FEW SECONDS ON THE ORIGI-
NAL REMOTE CONTROL TO GET A FUNCTION
, THIS FUNCTION MAY NOT
WORK IN A
MACRO ON YOUR REMOTE.
To Next Page
Loading...
Need help?
General
