12
Preparation
SETTING UP THE CAMERA
1. Remove the rubber cover from the
front of the camera, then use a
pointed object (such as a paper clip)
to slide the channel switch to any
setting (A, B, C, or D) to match the
setting on the receiver. Then replace
the rubber cover.
2. Hold the camera’s base and swivel
the camera’s head until it is in posi-
tion for the desired view.
3. Adjust the camera’s antenna so its
flat side faces in the direction of the
TV or monitor the receiver is con-
nected to.
4. Plug the camera’s barrel plug into
the power socket of the supplied
Plug ’n Power adapter.
49-2536.fm Page 12 Tuesday, October 10, 2000 11:38 AM
To Next Page
Loading...
Need help?
General
