Radio Shack HTX-200 - MEMORY OPERATION; Storing Frequencies in Memory

29
MEMORY OPERATION
Your HTX-200 has 30 standard memory locations that you can
use to store frequencies for quick access. For each memory loca-
tion, you can also store other settings such as the repeater offset,
CTCSS tones, and frequencies to pass or lock out during scan-
ning.
STORING A TRANSMIT/RECEIVE
FREQUENCY
1. Press
MR
.
and the last used memory location appear.
2. Repeatedly press or to select the desired memory
location.
------
appears if the memory location is empty.
3. Press
FUNC
+
MR
. The selected memory location and
flash.
4. Select the desired frequency by repeatedly pressing
or , or use direct frequency entry to select a frequency.
5. To enter a frequency offset for repeater operation, press
FUNC
+
SC
. The HTX-200 displays the current offset for the
calling frequency. Then press or to select the desired
offset. Press
PTT
to store your setting.
6. Press
FUNC
+
REV
to select the offset direction (+ or –). To
remove an offset for simplex operation, set the repeater off-
set to
0.0
.
7. If desired, set the tone squelch settings (see “Continuous
Tone Coded Squelch System Features” on Page 35).
8. Press
PTT
to store all settings, then press
MR
to exit the
memory mode.
MR
MR
19-1102RPO.fm Page 29 Friday, June 25, 1999 11:17 AM