Radio Shack HTX-200 - Key Tone and Memory Setting Check

39
TURNING THE KEY TONE ON AND OFF
The transceiver is preset to sound a beep each time you press a
key. To turn off the beep, press
FUNC
+ (
BEEP)
. disappears.
To restore the key tone, press
FUNC
+ (
BEEP
) again.
Note
: If the key tone feature is disabled, the power-on tone does
not sound.
CHECKING THE CURRENT MEMORY
SETTINGS
If you hold down
MO
(
REV
) for longer than 1 second, the squelch
opens and the set values for receive tone (
rT on
/
off
), transmit
tone (
tt on
/
off
), scan skip condition (
SCSP
)(if any), repeater
offset (
rPt
), and frequency step (
CS
) appear.
Release
MO
(
REV
) to turn on the squelch again.
SETTING THE FREQUENCY STEP
To change the frequency increment used during scanning and
stepping to a frequency, use the Main Menu to access the CS op-
tion setting (see “Using the HTX-200’s Menus” on Page 16). Then
repeatedly press or until you reach the desired setting. You
can change the frequency step to 5 kHz, 10 kHz, 12.5 kHz, 15
kHz, 20 kHz, 25 kHz, 50 kHz, or 1 MHz. (The example shown
here is 25 kHz.)
19-1102RPO.fm Page 39 Friday, June 25, 1999 11:17 AM