Radio Shack HTX-200 - SCANNING OPERATION; Scanning Modes and Settings

32
SCANNING OPERATION
SCANNING FOR ACTIVE FREQUENCIES
1. To search for activity on a frequency, press
SC
. The trans-
ceiver begins to scan up or down the full frequency range,
and it stops on each active frequency for the duration set by
the scan delay option (see “Using Scan Delay” on Page 32).
2. To change the scanning direction, press or .
3. To stop on a frequency or to stop scanning completely,
press
SC
again.
Using Scan Delay
If the HTX-200 stops on a signal during scanning, then
that signal
stops, the scan delay feature delays the continuation of scanning
to allow time for the signal to restart. Access the Main Menu (see
“Using the HTX-200’s Menus” on Page 16) to set the value. With
Sd
and the current delay time shown,
press or to select the
new delay time (between 1 and 30 seconds).
SCANNING STANDARD MEMORY
LOCATIONS
1. Press
MR
(so
appears), then press
SC
. The transceiver
scans all locations except empty locations and the ones you
programmed to be passed during scanning.
2. To change the scanning direction, press or .
3. To stop scanning, press
SC
again.
MR
19-1102RPO.fm Page 32 Friday, June 25, 1999 11:17 AM