15
+
or
–
— indicates the duplex offset direction. See “Overriding the
Duplex Offset” on Page 26.
DTMF
— appears when you turn on DTMF squelch. See “Using
DTMF Page” on Page 33.
HIGH
or
LOW
— indicates the transmit power level. See “Setting the
Power Level” on Page 17.
ON-AIR
— appears when you transmit. See “Transmitting” on
Page 22.
— appears when you turn on the Channel 1 alarm. Flashes
when there is a transmission on Memory Channel 1 and the alarm
is turned on. See “Checking Priority Channel 1” on Page 30.
M-CH
— appears when you tune to a memory channel. See “Mem-
ory Channels” on Page 13.
To Next Page
Loading...
