Radio Shack HTX-242 - Tuning to a Standard Memory Channel; Using the Calling-Frequency Memory; Checking Priority Channel 1

30
Tuning to a Standard Memory Channel
1. Press
MR
.
2. Rotate
M-CH
, or press
UP
or
DOWN
on the microphone, to
select the desired memory channel.
Using the Calling-Frequency Memory
Press
CALL
. The HTX-242 recalls all settings saved in the calling-
frequency memory.
Checking Priority Channel 1
To have the HTX-242 periodically “look back” at Memory Channel
1 to check for a transmission, press
F
then
ALM
. appears on the
display. The HTX-242 looks back at Memory Channel 1 every 4, 8,
12, or 16 seconds. If there is a transmission, the HTX-242 beeps to
let you know to tune to it, if desired.
Follow these steps to change the look-back time.
1. Press
VFO
.
2. Hold
F
for at least 1 second.
FUNC
flashes. Then press
MR
.
3. Repeatedly press
▲
until the HTX-242 displays
Lb
and the
current look-back time.
4. Rotate
TUNE
, or press
UP
or
DOWN
on the microphone, to
select the desired look-back time (4, 8, 12, or 16 seconds).
5. Press
MR
or PTT to save the setting.
Notes:
•
If you rotate TUNE, press UP or DOWN, or directly enter a fre-
quency, the HTX-242 returns to the last-used VFO.
•
To return to the mode selected before you used the calling-
frequency memory, press
CALL again.
!