Radio Shack PC-2 TRS-80 - Forward Space;Insert Characters

If you press CD or CD to go on to another program line, the Computer will not realize you have changed a line.
Any time a program is edited (changed), you must press (ENTE~ after the change!
Note that you can only delete one character at a time. If you want to erase two characters that are next to each
other, you will have to position the Cursor and press (SHIFT) ~ twice.
When (SHIFT) ~ deletes a character, it also deletes the space the character filled and all characters to the right
will move over
one space to the left. (You can also delete a character by pressing (SPACE) but this puts a space
where the character was.)
CB
Forward Space/Insert Characters
When you need to move the Cursor "forward" (to the right) without erasing characters, press CB .
Notice that this is not the same as pressing (SPACE) . If ,the Cursor is displayed at the beginning of a program line
and you move the Cursor by pressing (SPACE) ,you will erase a character, leaving a blank space in its place.
If you hold CB down, a repeat function will be activated and the Cursor will automatically move to the right
until
the end of the line is reached.
If you press (SHIFT) before pressing CB , you will put the Computer in the Insert Mode and you can insert a new
character between two existing ones. This will not replace any of the characters; it simply creates a blank space
between them so you can put a new character there.
38