Radio Shack PC-2 TRS-80 - Setting Up the PC-2

2/Setti ng Up the Pocket Co mputer
Start-Up
To turn the PC-2 on, simply press the (ON) key.
The Computer should respond with the Ready prompt ( > ) and indicators that tell you:
• If the Computer was last used to compute degrees, radians, or gradients.
• Which Operation Mode the Computer is in (PROgram, RUN, or RESERVE Mode).
• Which of the three Reserve Modes 0, II, or III) has been selected.
• Whether or not there's enough battery power to use the Computer.
On start-up, the PC-2 uses all mode settings that were being used when the Computer was turned off.
For instance:
....
SHIFT SMALL DEG RUN
Figure 4. Sample Display On Start-Up