13
CONNECTING LIGHTS OR
APPLIANCES TO MODULES
Caution:
Before you con-
nect any light or appliance
to a module, press
ALL
UNITS OFF
. This assures
that all of the modules are
powered off.
Set the power switch on the light or appliance to the on posi-
tion, then plug the light or appliance directly into the plug’s
power module. Plug the module into a wall outlet, if neces-
sary.
Write down your unit codes, module locations, and connect-
ed devices on the supplied chart. (See “Plug ’N Power Sys-
tem Chart” on Page 24.)
See “Operation” on Page 14 to test each module. See
“Troubleshooting” on Page 22 if your system does not work
properly.
61-2677CD.fm Page 13 Tuesday, July 6, 1999 11:05 AM
To Next Page
Loading...
