48 49
GLOB Menu Reference (Cont.)
Atten Mode – Attenuator reduces interference
from nearby transmitters. Global applies
attenuation to all objects. Normal uses object
attenuator settings.
Global Atten – On or off.
Clear Hits – Press SEL to clear all hit counters.
Hit Counts – Toggles the hit counter feature.
Dflt ScanList – Sets the default scan list for new
objects (0-22).
Priority – On or Off.
WxPri – Off or select 1 of the 7 WX channels
Scan Lists – Enters the scan list sub menu.
SRCH L/Outs – Enters the search lockout
frequencies sub menu.
Clear FAV – Clears the Favorites Scan List.
Memory Info – Displays memory usage.
Tune LED – Activates signal strength driven LED
in Tune mode.
Color 0-7 – LED colors. Use number keys for
preset intensity levels. Use the four-way keypad
for RGB LED settings for each LED and to adjust
intensity.
Qtxt 1-0 – Sets QuickText (1-10).
Key Repeat – Key repeats when held down. On or
Off.
LCD BlinkOff – For alternating text displays, sets
the display time for the secondary display element
(1-250 x 10 mS).
LCD BlinkOn – Sets the display time for the
primary display element (1-250 x 10 mS).
LED BlinkOff – When Alert LED is set to Flash, the
LED OFF duration (1-250 x 10 mS).
LED BlinkOn – When Alert LED is set to Flash, the
LED ON duration (1-250 x 10 mS).
GLOB Menu Reference (Cont.)
Pri Channels – Number of priority CONV channels
to check during a priority scan sampling (0-250,
0=All CONV priority channels).
Pri Interval – Priority sample interval (2-100 x
100 mS).
TGRP Pri Int – Priority interrupt during trunked
calls (On or Off).
QuickPriRtn – On or Off. When On, does not
wait for verification of CTCSS, DCS or NAC when
returning to an active CONV channel after priority
sampling
Search Delay – Delay for all search modes (1-250
x 100 mS).
SRCH Dig AGC – On or Off. Digital AGC for all
search types compensates for low or high digital
audio levels caused at the system.
SRCH SuprTrk – On or Off. Alternative DSP
decoding algorithm is applied to all search types.
TLO=FUNC L/O – When No, L/OUT = Temporary
Lockout; when Yes, L/OUT = Permanent Lockout.
DupeChecksSQ – Yes or No. Checks both
frequency and encoded squelch settings when
checking for duplicate CONV objects.
TGID Format – Norm, DEC, or HEX.
TGRP Ignore – Yes or No. Ignore calls on TGRPS
that are mapped to disabled Scan Lists.
ShowCCInfo – Yes or No. For Motorola and
P25 systems, the display alternates the voice
frequency and current control channel index (from
TSYS frequency list) and frequency.
Set Password – Set Power-on password.
0000=none.
To Next Page
Loading...
