How to fix Radio Shack PRO-94 when it is on but will not scan?
If your scanner is on but not scanning, it might be due to incorrect SQUELCH adjustment. Try adjusting the SQUELCH. Alternatively, ensure you have stored frequencies into more than one channel, as scanning requires multiple stored channels.
What to do if Radio Shack PRO-94 keypad does not work?
If the keypad isn't working, the keylock function might be activated. To deactivate it, press the KEYLOCK button until 'K/L' disappears from the display.
What to do if my Radio Shack PRO-94 Scanner is totally inoperative?
If your Radio Shack Scanner is totally inoperative, check the batteries or ensure the AC or DC adapter is properly connected. Recharge or replace the batteries if they are weak. Also, make sure the adapter’s barrel plug is fully plugged into the POWER jack.
Why is my Radio Shack PRO-94 Scanner on but will not scan?
If your Radio Shack Scanner is on but not scanning, it might be due to the SQUELCH not being adjusted correctly. Try turning the SQUELCH clockwise. Another reason could be that only one or no channels are stored, so store frequencies into more than one channel.
What to do if BATT. Lo flashes on my Radio Shack PRO-94 Scanner?
If 'BATT. Lo' is flashing on your Radio Shack Scanner, it means the batteries are weak. You should recharge rechargeable batteries or replace non-rechargeable batteries.
Why does my Radio Shack PRO-94 have poor or no reception?
Poor or no reception on your Radio Shack Scanner can be caused by weak or completely discharged batteries. Check the batteries or ensure the AC or DC adapter is properly connected. Also, ensure an antenna is correctly connected to the scanner.
What to do if the keypad does not work on my Radio Shack PRO-94 Scanner?
If the keypad on your Radio Shack Scanner isn't working, the keylock function might be activated. To turn it off, press KEYLOCK until K/L disappears.
What does it mean if 'Error' appears on my Radio Shack PRO-94 Scanner?
If 'Error' appears on your Radio Shack Scanner, it indicates a programming error. Re-enter the frequency correctly, making sure to include the decimal point.
Why does the Radio Shack Scanner’s display dim or sound a tone?
If your Radio Shack Scanner's display dims or it sounds a tone every 15–30 seconds, it could be due to incorrectly installed or weak batteries. Make sure the batteries are installed properly, and recharge or replace them if they are weak.
What to do if my Radio Shack Scanner locks on frequencies that have an unclear transmission?
If your Radio Shack Scanner locks on frequencies with unclear transmissions, it might be locking onto 'birdie' frequencies. Avoid storing frequencies listed under “Birdie Frequencies” or only listen to them manually.
General| Type | Handheld Scanner |
|---|---|
| Channels | 200 |
| Modulation | AM, FM, WFM |
| Weight | 10.6 oz |
| Priority Scanning | Yes |
| Close Call RF Capture | Yes |
| Bands | VHF, UHF |
| Power Supply | AC Adapter |
| Power | 9V |
To Next Page
